Dual Ski Bracket System

The CFR dual ski bracket system is the best way to get your skis and poles to the top of the mountain safely on your snowmobile. This system can be used with another dual ski bracket on the other side to carry up to two pairs of skis and poles. It also can be used with a snowboard bracket system to carry a snowboard on one side of snowmobile and skis/poles on the other side of snowmobile. When two dual ski brackets are being used it is putting a lot of extra weight on the rear tunnel. Slow down going through rough conditions. Extra tunnel supports are a good idea if you frequently travel in rough conditions with two pairs of skis.

Mounting Instructions

Parts List:
- Dual ski rear bracket X 1
- 153/4”  strap with ratchet buckle and ladder strap X 1
- Dual ski front bracket X 1
- 14” strap with ratchet and ladder strap X 1

Tools Needed:

- Drill with 9/32nd and 1/8th inch pilot hole drill bit.
- 1 ratchet with a 7/16th or 11m socket.
- 1 7/16th or 11m open end wrench

Step #1
Make sure you have purchased the CFR Double -D rack. It is the base of the CFR Dual ski bracket system.
Step #2
Drill mounting holes of Dual ski bracket system on rack before mounting rack on snowmobile. After holes are drilled, secure rack on snowmobile using instructions included with rack. After rack is mounted on snowmobile precede to mount Dual Ski system brackets.
Step #3
Look at the diagram on front of instructions and drill four 1/8th pilot holes. Switch drill bit to 9/32nd. Drill inside pilot holes on the side of the rack in Dual ski mounting holes.
Step #4
The Dual ski rear bracket mounts towards the back of rack and uses the longer 153/4” strap. The Dual ski bracket rear piece has a rectangle hole in the middle. The Dual ski front bracket mounts towards the front of rack and uses the 14” strap. Secure pieces to rack using hardware provided.  Keep bolts holding straps hand tight so you can adjust sizes when skis and poles are in rack.
Step # 5
Place skis in rack system so the front binding goes in between the two mounting brackets on the side of the rack.
-Tips of skis should rest on running boards. Place poles on top of skis. The strap with aluminum buckle of each mounting bracket system should be placed over the skis and poles and into the ladder strap on the side of each bracket. Ratchet down snug.
-Adjust lengths of straps by unbolting and making them bigger or smaller using holes in straps.
-To remove skis push down on ratchet release levers and pull up on strap.

Go skimobiling A.S.A.P.